Sundance Spas 680 User Manual download pdf (Page 35)

Page 31

13.0 Error Conditions / Error Messages

Your spa has a self-diagnostic control system. The system will automati-

cally display the following if a problem is detected.

13.1 Panel displays SN1

Open sensor (heater is disabled) or shorted sensor (spa is

deactivated). The high-limit temperature sensor is not

functioning. Your authorized Sundance dealer must repair this.

13.2 Panel displays SN2

Open or shorted sensor (heater disabled). The temperature

sensor is not functioning. Your authorized Sundance dealer

must repair this.

13.3 Panel Displays FL1

Pressure switch is not closed when the pump is activated.

Heater is deactivated. Proper flow of water is inhibited or

pressure switch has malfunctioned. Check for proper water

level, pump is primed and/or clogged filter. Contact a qualified

service technician.

13.4 Panel Displays FL2

Pressure switch is closed, while pump is deactivated.

Contact a qualified technician.

13.5 Panel displays COL

Cool Condition - Temperature has dropped 20°F (11°C) below

the current set temperature. The pump and heater have been

activated to bring the temperature to within 15°F (8°C) of the

set temperature. No corrective action is required. Note: during

cold periods, you may consider increasing the number of filtra-

tion cycles (page 24).

13.6 Panel Displays ICE

Freeze Protection - A potential freeze condition has been

detected. No action is required. The pump and heater will

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 43 44

No comments

Sundance Spas 680 User Manual Page 35