Sundance Spas 680 User Manual download pdf (Page 37)

Page 33

14.0 Troubleshooting Procedures

In the event your spa is not working the way it should, please first review

all the installation and operating instructions in this manual and check

the message on the panel display. If you are still not satisfied it is work-

ing properly, please follow the appropriate troubleshooting instructions.

Note: If any of the supply cords to the accessories are damaged, they

must be replaced by authorized service personnel.

14.1 None of the Components Operate (e.g. Pump, Light)

Check the following when none of the spa components operate

(e.g. jets pumps or light):

1. Is there power to the spa?

2. Is the household circuit breaker tripped?

3. Call your authorized dealer.

14.2 Pump Does Not Operate but Light Does

Press the JETS Button:

1. If no water movement is detected, make sure power is going to the

spa and check the water level. If it does not solve the problem, con-

tact your authorized Sundance dealer.

2. The main pump operates but no water flows to jets. Pump may not

be properly primed. This can happen after the spa is drained and

refilled. Press the JETS 1 button several times, never leaving the

motor on for more than 5 to 10 seconds at a time. Turn power off

and let the air out removing the filter cartridge. Refer to section 11.1

(page 25). Make certain you reinstall the filter cartridge before

turning on spa power and restarting the jets pump.

14.3 Poor Jet Action

1. Press the JETS 1 button to make certain the pump #1 is on.

2. Open all air control to the “on” position.

3. Check for dirty filter. Clean, if necessary.

4. Make sure jets are all the way open.

14.4 Water is Too Hot

Reduce thermostat setting.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 43 44

No comments

Sundance Spas 680 User Manual Page 37