Sundance Spas 680 User Manual download pdf (Page 16)

Page 12

ANSI/NFPA 70. The disconnecting means must be readily

accessible to the spa’s occupant but installed at least 5 feet (1.5m)

from spa water.

6. The electrical circuit supplied for the spa must include a suitable

ground fault circuit interruptor (GFCI) as required by NEC Article

680-42.

7. To gain access to the spa’s power terminal block, remove the

screws securing the cabinet panel on the side of the spa under the

control panel (page 20). Then remove the four control box door

screws and door (Figure-B).

8. Select the power supply inlet you want to use (Figure-A). Feed

power cable to control box, then install it through the large opening

provided in the bottom side of the box.

9. Connect wires, color to color, on terminal blocks TB1 and TB3

(Figures C-F). TIGHTEN SECURELY! All wires must be hooked up

securely or damage could result.

10. Install control box door and screws and reinstall the cabinet side

panels.

2 2

Figure-A

Equipment Area

1. Control Box

2. Power Supply Inlet(s)

3. 2-Speed Pump #1

4. Heater

5. Pump Drain Plug

6. 1-Speed Pump #2

7. Optional CD Ozonator

(Purchased Separately)

8. Ozone Injector

Flow

Note: Pump Locations Vary by Model

5 5

Burlington Model Illustrated

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 43 44

No comments

Sundance Spas 680 User Manual Page 16