Sundance Spas 680 User Manual download pdf (Page 20)

Page 16

8. Place Cover On Spa

• Keeping the insulating cover in place anytime the spa is not in use

will reduce the time required for heating, thereby minimizing

operating costs.

• The time required for initial heat-up will vary depending on the

starting water temperature.

DANGER:

Risk of injury, always check water temperature

carefully before entering spa!

Decontamination Procedure (Steps 9-15)

Steps 9-15 below are only required when sanitizer levels are unstable

after performing steps 1-6 above. Disregard steps 9-15 below if sanitizer

levels remain stable at 3 ppm to 5 ppm after performing steps 1-6 above.

9. Add 2.5 ounces of sodium dichlor for every 100 gallons of water.

Refer to the table below for approximate water ll volume by model.

CAUTION: Never add chlorine tablets (trichlor) to your

spa for any reason! This chemical may damage components

within your spa and void the manufacturer warranty.

Water Fill Volume by Model

Spa Model Approximate Fill Volume

Denali ........................................ 220 US Gallons (833 Liters)

Tacoma ...................................... 105 US Gallons (397 Liters)

Burlington .................................. 340 US Gallons (1,287 Liters)

10. Leave spa cover open during this step to allow excessive chemical

vapors to exit spa, protecting plastic knobs and pillows on Tacoma

and Burlington models from chemical attack. If spa is indoors, open

doors and windows for proper ventilation. Turn on all

spa jets pumps for one hour, open all air controls. On

Denali models, place the Divert-A-Jet in their center

“combo” position as shown (right). Note: You will need

to press the jets pump button(s) every 20 minutes since

these functions have an automatic 20 minute time-out

function that turns them off.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 43 44

No comments

Sundance Spas 680 User Manual Page 20